Body3

The body





	On the inside of the rear door I installed 2 x blue leds to give a movie-like look. So when the rear door opens the led in the center of the grabble and on the inside of the door lights up. This gives a very similiar look as on the screen shot above.




	I glued a Neodyn magnet (diameter 20mm) to the inside of the sidevent.
I then welded a washer to a M6 bolt and mounted it to the Frame.	This way the vent is firmly attached but can be removed without problem.

	New servoholder: 2mm instead of 1,5mm and also welded. These holders are then bolted to the utility arm carrier. A new plate for the Picaxe with M3 studs.
$Beskrivning: C:\Websidor\r2d2\images\R2_utilityarm_8.jpg$	$Beskrivning: C:\Websidor\r2d2\images\R2_utilityarm_5.jpg$
$Beskrivning: C:\Websidor\r2d2\images\R2_utilityarm_6.jpg$	$Beskrivning: C:\Websidor\r2d2\images\R2_utilityarm_7.jpg$
$Beskrivning: C:\Websidor\r2d2\images\R2_lifescanner_1.jpg$ Life scanner screen.	$Beskrivning: C:\Websidor\r2d2\images\R2_frame_15.jpg$ 90 degree doorenclosure
$Beskrivning: C:\Websidor\r2d2\images\R2_misc_11.jpg$	$Beskrivning: C:\Websidor\r2d2\images\R2_misc_12.jpg$ Parts to become Persicope/scanner/sabel lifter.
$Beskrivning: C:\Websidor\r2d2\images\R2_misc_8.jpg$	$Beskrivning: C:\Websidor\r2d2\images\R2_misc_10.jpg$
$Beskrivning: C:\Websidor\r2d2\images\R2_misc_9.jpg$ Front and rear vents made from sheetmetal parts, glued together.	$Beskrivning: C:\Websidor\r2d2\images\R2_powercoupling_1.jpg$ David Shaw's awesome parts.
$Beskrivning: C:\Websidor\r2d2\images\R2_coinslot_3.jpg$	$Beskrivning: C:\Websidor\r2d2\images\R2_coinslot_1.jpg$ David Shaw's awesome parts.
$Beskrivning: C:\Websidor\r2d2\images\R2_coinslot_2.jpg$